Bosch WAT28400UC Instructions for Use - Page 10
Installation instructions - canada
View all Bosch WAT28400UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Under counter (Less Desirable) ( + ) * If front of the appliance is covered ventilation openings must be installed. E & F are minimum area sizes E 63 sq.in. F 63 sq.in. 404 sq.cm 404 sq.cm G & H actual spacing dimensions for min. open area sizes G 3 in. 7.6 cm H 14 in. 35.6 cm Installation instructions 9 WARNING RISK OF FIRE, ELECTIRICAL SHOCK OR INJURY TO PERSONS To reduce the risk of fire, electric shock or injury to persons, read the Important Safety Instructions at the front of this manual before installing or operating this appliance. 9 CAUTION WASHING MACHINE IS HEAVY Use additional help and care when lifting and positioning. Introduction Read these installation instructions completely and carefully before starting to install your new washing machine. The information contained can save you time and effort and will help to ensure optimum performance of your new washer. Be sure to observe all warnings and cautions. NOTICES ▯ Frozen hoses can tear or burst. Do not install the washing machine outdoors or in an area exposed to freezing condtions. ▯ If the washing machine is located in a room which will be exposed to temperatures below freezing, or if it is located in a cabin that is being shut down for the winter, any residual water in the pump or water inlet hose(s) must be drained. ▯ Take care not to damage the washing machine. Do not hold on to protruding parts (e.g. door) when lifting. Do not push against the appliance door glass due to risk of damage. ▯ In addition to the safety information listed here, the local water and electric authorities may have special requirements that must be followed. ▯ If in doubt, have the appliance installed by an authorized technican. ▯ Hidden surfaces may have sharp edges. During service use caution when reaching inside the washer housing. These installation instructions are intended for use by qualified installers. In addition to these instructions, the installation must comply with: - for the United States - National Electrical Code, ANSI/ NFPA70 - and latest editions of the State and municipal and/or local regulations. - for Canada - Canadian Electrical Code C22.1 - and the latest editions of the Provincial, Municipal and/or local regulations. 10