Bosch WAT28400UC Instructions for Use - Page 14
hose and parts included with your washer. - 20
View all Bosch WAT28400UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
▯ The water supply pressure must be between 14,5 to 145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons (8 liters) of flow per minute. A pressure regulator valve must be installed if the maximum water pressure is exceeded. ▯ Make sure the water supply faucet is easily accessible when the washer is in use. The faucet should be turned off if the washer is going to be unused for extended periods of time. ▯ Make sure rubber washers are in place at both ends of the water supply hose. Missing washers could cause leaks. ▯ The connection points are under full water pressure. Turn on the water tap and check for leaks. ▯ Periodically inspect the water supply hose and replace with a new hose if cuts, kinks or leaks are observed. Water drain hose connection NOTICES ▯ Do not reuse an old drain hose. Only use the drain hose and parts included with your washer. ▯ Do not kink or modify the water drain hose. Height of drain point Height difference between the floor and drainage point: max. 39 in. (100 cm). Types of drainage hookups Standpipe LQ GUDLQ SLSH FDEOHWLH Water connection hoses ▯ red - Hot water-hose ▯ blue - Cold water-hose Attach the drain hose to the elbow included with your washer. Position the elbow on the drain hose 4" from end of hose as shown. Insert this section of the drain hose into the drain pipe. Secure the elbow and hose with a nylon tie strap or the equivalent to keep the hose from coming out of the drain pipe during use. Sink siphon Attach this end to water tap. Hand tighten only. Secure the drain hose to the sink siphon using a Ø 0.9 1.6 in. (20-44 mm) hose clip (available from a hardware store). Attach this end of the hose to the back of the washing machine. Hand tighten only. 14