Brother International LK3-B438E MKII Instruction Manual - English - Page 13

. Installing the motor, so that the key groove is aligned, and then tighten

Get Brother International LK3-B438E MKII PDF manuals and user guides View all Brother International LK3-B438E MKII manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

3. INSTALLATION 3-2 . Installing the motor q u Install the motor u to the work table with the four ac- cessory bolts q, cushions w, cushion collars e, flat q washers r, spring washers t and nuts y. At that time, fix by setting bolts q a little to the right of oval hole on motor. NOTE: Tighten the nuts y so that the clearance between the table and the cushion collars e is approximately 1 mm. w e r t y 1mm Table e 3-3 . Installing the motor pulley q w e Place the motor pulley q onto the shaft of the motor w so that the key groove is aligned, and then tighten the set screw e so that the center of the V groove in the motor pulley q is aligned as closely as possible with the center of the belt hole in the power table. 7 LK3-B438E Mark II

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
LK3-B438E Mark II
7
q
w
e
r
y
u
q
e
Table
1mm
t
q
w
e
3-2 .
Installing the motor
Install the motor
u
to the work table with the four ac-
cessory bolts
q
, cushions
w
, cushion collars
e
, flat
washers
r
, spring washers
t
and nuts
y
.
At that time, fix by setting bolts
q
a little to the right
of oval hole on motor.
NOTE:
Tighten the nuts
y
so that the clearance between the table
and the cushion collars
e
is approximately 1 mm.
3-3 . Installing the motor pulley
Place the motor pulley
q
onto the shaft of the motor
w
so that the key groove is aligned, and then tighten
the set screw
e
so that the center of the V groove in
the motor pulley
q
is aligned as closely as possible
with the center of the belt hole in the power table.
3. INSTALLATION