Brother International LK3-B438E MKII Instruction Manual - English - Page 41
Adjusting the holding pressure, 10-10. Adjusting the position of the button holder
View all Brother International LK3-B438E MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
10 . STANDARD ADJUSTMENTS 10-9. Adjusting the holding pressure Loosen the adjusting nut q and turn the adjusting nut w to the point where it is just tight enough that the material will not slip out of place when it is slightly pulled (keep pressure as slight as possible). w q 10-10. Adjusting the position of the button holder 1. Loosen the two hexagonal bolts q and adjust the button holder body w by moving it. 2. Check that the needle will go through the button hole with no contact. (Refer to "6. CHECKING THE SEWING PATTERN".) q w 35 LK3-B438E Mark II
35
LK3-B438E Mark II
10 . STANDARD ADJUSTMENTS
q
w
10-9. Adjusting the holding pressure
Loosen the adjusting nut
q
and turn the adjusting nut
w
to the point where it is just tight enough that the
material will not slip out of place when it is slightly
pulled (keep pressure as slight as possible).
10-10. Adjusting the position of the button holder
1.
Loosen the two hexagonal bolts
q
and adjust the
button holder body
w
by moving it.
2.
Check that the needle will go through the button
hole with no contact. (Refer to “6. CHECKING THE
SEWING PATTERN”.)
w
q