Brother International LK3-B438E MKII Instruction Manual - English - Page 37
. Adjusting the driver needle guard, 10-4 . Adjusting the needle clearance
View all Brother International LK3-B438E MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
10 . STANDARD ADJUSTMENTS 10-3 . Adjusting the driver needle guard Needle center line Tip q ew Turn the machine pulley to align the tip of the rotary hook with the needle center line. Then loosen the set screw w and turn the eccentric shaft e to adjust so that the driver needle guard q contacts the needle. If the needle contact pressure is too great, skipped stitches may occur. On the other hand, if the driver needle guard qis not touching the needle, the tip of the inner rotary hook will obstruct the needle, resulting in an excessively high amount of friction. 10-4 . Adjusting the needle clearance 0.01 - 0.08mm q w Turn the machine pulley to align the tip of the rotary hook with the needle center line. Then loosen the set screw q and turn the eccentric shaft w to adjust so that the clearance between the needle and the rotary hook is 0.01 - 0.08 mm. 10-5 . Adjusting the shuttle race thread guide q Install the shuttle race thread guide q by pushing it in the direction of the arrow so that the needle groove is aligned with the center of the needle plate hole. NOTE: If the shuttle race thread guide is in the wrong position, thread breakages, soiled thread or catching of the thread may occur. 31 LK3-B438E Mark II