Brother International MFC-J6510DW Quick Setup Guide - English - Page 28

For Wireless Network Users 20 Configure the wireless settings (typical Wireless Setup in infrastructure mode) IMPORTANT You must have the wireless settings you wrote down for your network in step 19 on page 27 before you proceed. a On your machine, press Menu. Press a or b to choose Network and press OK. Press a or b to choose WLAN and press OK. Press a or b to choose Setup Wizard and press OK. When Network I/F switched to Wireless. is displayed, press OK to accept. This will start the wireless setup wizard. To cancel, press Stop/Exit. b The machine will search for available SSIDs. It will take several seconds to display a list of available SSIDs. If a list of SSIDs is displayed, press a or b to choose the SSID you wrote down in step 19-a on page 27, then press OK. If the wireless access point/router of the selected SSID supports WPS and the machine asks to use WPS, go to c. If the machine asks to enter a Network Key, go to d. Otherwise, go to e. Note • If a list of SSIDs is not displayed, make sure your access point is on. Move your machine closer to the access point and try starting from a again. • If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. For details, see the Network User's Guide. c Press 1 (Yes) to connect your machine using WPS. (If you choose 2 (No) to continue manual setting, go to d to enter a Network Key.) When the LCD shows Start WPS, press the WPS button on your wireless access point/router, and then press 1 (Next) to proceed. Go to e. d Enter the Network Key you wrote down in step 19-a on page 27 using the dial pad to choose each letter or number. The letters appear in this order: lower case, upper case and then numbers. To move the cursor left or right, press d or c keys. (For more information, see Entering Text for Wireless Settings on page 39.) Press OK when you have entered all the characters, then press 1 (Yes) to apply your settings. e Your machine will now try to connect to your wireless network. It may take a few minutes. f A connection result message appears for 60 seconds on the LCD and a wireless LAN report will automatically be printed. If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 30. Wireless setup is now complete. A four level indicator on the bottom of your machine's LCD will show the wireless signal strength of your access point/router. To install MFL-Pro Suite, continue to step 21. For Windows® Users: Now go to Page 32 For Macintosh Users: Now go to Page 36 28