Brother International S-7220B Instruction Manual - English - Page 50
CLEANING, <Resetting the grease consumption amount>, Press the rightmost - ' 405
View all Brother International S-7220B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
11. CLEANING grease 1. Turn the pulley to raise the needle bar to a position where the slide block guide (1) can be seen. 2. Apply grease to the slide block guide (1) in the places shown in the illustration. 3754M 3755M 1. Turn the power switch to "OFF". 2. Remove the screws. 3. Apply grease to each of the holes until the grease overflows slightly. 4. The grease will be pushed in when the screws are tightened. 5. Turn the machine pulley by hand to move the needle bar up and down several times in order to disperse the grease. 6. Use a cloth to wipe away any excess grease from around the screws. 7. Carry out the reset procedure given below. 3756M After the grease has been applied, carry out the following procedure to reset the grease consumption amount. 1. Turn the power switch to "ON". "GrEASEUP" will flash in the main display (1) and the buzzer will sound. 2. Press the RESET key (2). The main display (1) will change to stitch number display mode. 3. Press and hold the LOCK key (4) for 2 seconds or more. The lock icon (5) will switch off and the lock will be released. 4. Press the FUNC (Function) key (6). "n.134 Pxxx" will appear in green in the main display (1). ("Pxxx" indicates the grease consumption amount. For example, "P100" means that 100% of the grease has been consumed.) 5. Press the rightmost key (7). The "Pxxx" will change to "P 0". 6. Press and hold the ENTER key (8) for two seconds or more. The buzzer will make a long beep, and then the main display (1) will change to stitch number display mode. 7. Depress the treadle to run the sewing machine for 1 second or more. 8. Turn the power switch to "OFF". (This completes the reset procedure.) 2139M 43 S-7220B