Canon 3060 Startup Guide - Page 22
Terminator Setting
View all Canon 3060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Terminator Setting The terminator should be set to "ON" only in the SCSI device that is at the end of the SCSI daisy chain. If the scanner is the only SCSI device that is being connected to the PC, or if the scanner is being connected at the end of a daisy chain of SCSI devices, set bit 1 of the scanner's DIP switch (terminator) to ON, and disable terminator for all other SCSI devices. Terminator OFF Terminator ON If another SCSI device is located at the end of the daisy chain, turn the scanner's terminator "OFF," and turn the terminator in the last SCSI device "ON." Terminator OFF Terminator ON (or attached) CAUTION When the scanner is the last device on the SCSI bus, enable termination either by DIP switch or by attaching a terminator plug. Note that incorrect operation may result if a terminator plug is attached while termination is enabled by DIP swtich. 18 Installing the Scanner