Canon EOS-1D EOS-1D Instructions - Page 162
Troubleshooting Guide
UPC - 013803005912
View all Canon EOS-1D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Troubleshooting Guide If there is a problem, first refer to this Troubleshooting Guide. Power Source The battery cannot be recharged. You are using the wrong battery. s Use the dedicated Ni-MH Pack. (→p.22) The battery is not properly attached to the charger. s Attach the battery properly to the charger. (→p.22) The camera does not operate even when the < > switch is set to < >. The battery is exhausted. s Recharge the battery. (→p.22) The battery is not installed properly. s Install the battery properly. (→p.23) The CF card slot cover is open. s Push in the CF card until the CF card release button pops up. Then close the CF card slot cover. (→p.27) The access lamp still blinks even when the < > switch is set to < >. If you set the < > switch to < > right after taking a picture, the access lamp will still blink for a few seconds while the image is recorded onto the CF card. s When the camera finishes recording the image to the CF card, the access lamp will stop blinking and the power will turn off. The battery becomes exhausted quickly. The battery is not fully charged. s Recharge the battery fully. (→p.22) The battery's service life has expired. s Replace the battery with a new one. (→p.166) The camera turns Auto power off is in effect. off by itself. s Set the < > switch to < > again or set auto power off to "Off." (→p.130) Only the < > The battery has almost exhausted. icon is displayed on s Recharge the battery. (→p.22) the top LCD panel. 162