Canon PIXMA MX870 Solución de problemas de configuración de red - Page 8

ENGLISH Problems during Software Installation WPS The Machine is Not Displayed (Detected) Cannot connect. Multiple access points are enabled. is Displayed Check Action A A The message appears when multiple access points are detected. Wait for a while, then configure the settings again. Connection failed. is Displayed Check The message appears when an error occurs. Check the access point settings, then configure WPS settings again. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" in the printed manual: Getting Started. • When using an access point that does not support WPS, configure settings manually. For the procedure to configure settings of the machine manually, refer to "Wireless Setup" in the printed manual: Getting Started. Check 1 For a wireless connection, make sure that you follow Check 1, 2, 3, 4, 5 and 6 of "Connection Checklist" on page 15, then click Update (A). For a wired connection, make sure that you follow Check 1, 2, 3, 7 and 8 of "Connection Checklist" on page 15, then click Update (A). Check 2 Is the machine connected to a network? • To confirm the connection status, press the Setup button, then using the { } [ ] and OK buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list or LAN setting list. Make sure that Connection is set to Active. If the machine is not connected to a network, perform setup again by following the procedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printed manual: Getting Started.