Canon imagePROGRAF TM-300 series User Manual - Page 183

Enlarge/Reduce Enlarges or reduces images This setting item is displayed by tapping in the following order. (Setup) > Device settings > Print settings > HP-GL/2 print settings > Paper settings • Fit paper size Enlarges or reduces the image for printing to fit to the paper loaded in the printer. Note • Data line widths are not enlarged or reduced. • Margin widths are not enlarged or reduced. Because of this, paper size scaling and post-processing image scaling may not be the same. • The maximum enlarge/reduce rate for this setting is calculated by (maximum width/1 inch x 100 %). Therefore, the maximum rate is 2400 % for 24 inch model, 3600 % for 36 inch model, and 4400 % for 44 inch model. If the calculation result exceeds the maximum rate, the image is enlarged according to the maximum rate for each model. • Same size (Initial setting) Image is not enlarged/reduced. • Scaling Enlarges or reduces the image to the specified scaling value for printing. Scaling can be specified within a range of 25 % to 400 %. Note • Data line or margin widths are not enlarged or reduced. ENLARGE/REDUCE Scaling SETTING EXAMPLE The output object area is enlarged or reduced as specified by the Scaling setting. The origin is in the upper-left corner. For example, doubling the length and width of A4 size paper results in A2 size paper. If there are margins of 3 mm, the A4 size output object area measures 291 mm x 204 mm. Specify a value of 200% for the Scaling setting to produce a post-processing size of 582 mm x 408 mm. (Note that ambient conditions may cause paper to expand and contract.) 183