Canon imagePROGRAF iPF650 iPF650 655 750 755 Setup-Guide - Page 4

Install the Printhead Next, install the printhead. 1 Open Upper Cover is shown on the display screen. As instructed, open the top cover. a • When installing the printhead, do not move the carriage (a) from the position shown in the figure. If you move the carriage (a), a warning noise sounds and the printhead cannot be installed. If you have moved the carriage (a), close the top cover. The carriage (a) moves to the position shown in the figure. 2 Pull the printhead fixer lever forward all the way to open it completely. Instructions on printhead replacement are shown on the display screen. Lift the printhead fixer cover to open it 3 fully. Hold the printhead by the grips (a) as you 4 remove it from the pouch. 5 Remove the orange protective part (a). To remove orange protective part (b), push the grip (c) as you remove the part. bc a a a • Never touch the parts covered by the protective part. This may damage the printhead and affect printing quality. • The printhead contains ink, so be careful not to spill it once the protective part is removed. • Do not reattach the protective part after removing it. Dispose of these materials according to local regulations. Insert the printhead into the carriage (b) 6 with the ink holes (a) facing away from the printer as shown in the figure. Carefully push the printhead firmly into the carriage (b), ensuring that the part covered by the protective part does not touch the carriage. a 7 Pull the printhead fixer cover down toward the front to lock the printhead in place. 8 Push the printhead fixer lever all the way back. b 9 Close the top cover. 4