Casio 140CR User Manual - Page 10

Loading Paper Roll And Replacing The Printer's Ink Roll

Page 10 highlights

Part-1 QUICK START OPERATION 2. Loading Paper Roll And Replacing The Printer's Ink Roll Mode Switch REG CAL X Z OFF * Replace the printer cover by * Load new paper following the placing the cover's front tab instructions above, and re- into the register's groove. place the printer cover. RF PGM 1. To load journal paper ! Remove the printer cover by lifting up the back. 2. To remove journal paper ! Remove the printer cover fol- Default printer setting is for lowing the instructions above. Journal. @ Press the l key until ap- To print receipts, please refer to proximately 20cm of the pa- 1-7-3 on page 24 to switch the per is fed from the printer. printer for Receipt or Journal. # Cut off the roll paper. @ Put a roll of journal paper into the holder. # Cut the leading end of the roll paper with scissors and insert the paper into the inlet. ◗ To load receipt paper ! To use the printer to print receipts, follow steps 1 through 4 of "To load journal paper". @ Pass the leading end of the receipt paper through the $ Remove the take-up reel printer cover's paper outlet from the printer and take off and replace the printer cover. the left plate of the reel. # Tear off any excess paper. % Remove the journal paper from the take-up reel. $ Press the l key until 20 or 30 cm of paper is fed from the printer. % Roll the paper onto the takeup reel a few turns. ^ Cut off the paper left in the printer and press the l key until the remaining paper is fed out from the printer. ^ Set the left plate of the takeup reel and place the reel into the register. & Remove the core of the paper. & Press the l key to take up Options: Roll paper - P-5860 any slack in the paper. Ink Roll - IR-40 E 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

10
E
Part-1
QUICK START OPERATION
2.
Loading Paper Roll And Replacing The Printer’s Ink Roll
Mode Switch
REG
OFF
RF
PGM
CAL
Z
X
*
Replace the printer cover by
placing the cover’s front tab
into the register’s groove.
2. To remove journal paper
!
Remove the printer cover fol-
lowing the instructions above.
@
Press the
l
key until ap-
proximately 20cm of the pa-
per is fed from the printer.
#
Cut off the roll paper.
$
Remove the take-up reel
from the printer and take off
the left plate of the reel.
%
Remove the journal paper
from the take-up reel.
^
Cut off the paper left in the
printer and press the
l
key
until the remaining paper is
fed out from the printer.
&
Remove the core of the pa-
per.
1. To load journal paper
!
Remove the printer cover by
lifting up the back.
@
Put a roll of journal paper
into the holder.
#
Cut the leading end of the
roll paper with scissors and
insert the paper into the inlet.
$
Press the
l
key until 20 or
30 cm of paper is fed from
the printer.
%
Roll the paper onto the take-
up reel a few turns.
^
Set the left plate of the take-
up reel and place the reel
into the register.
&
Press the
l
key to take up
any slack in the paper.
*
Load new paper following the
instructions above, and re-
place the printer cover.
To load receipt paper
!
To use the printer to print re-
ceipts, follow steps 1 through
4 of
“To load journal paper”.
@
Pass the leading end of the
receipt paper through the
printer cover’s paper outlet
and replace the printer cover.
#
Tear off any excess paper.
Default printer setting is for
Journal.
To print receipts, please refer to
1-7-3 on page 24 to switch the
printer for Receipt
or Journal.
Options:
Roll paper –
P-5860
Ink Roll – IR-40