Clifford Concept 30 Owners Guide - Page 14

Example of setting a new valet code: Let's say you want to change the code from its original single-digit "2" code to a double-digit code of "31." You would do the following: Turn the ignition on, enter your current code, tap the momentary side of the PlainView switch 8 times, press the latched side, then enter the new code: momentary, momentary, momentary, latched (3 chirps), momentary, latched (1 chirp), center. Wait 2 seconds for the system to exit program mode (1 chirp and the LED turns off), then turn the ignition off (3 chirps). Dual-sensor protection Your Concept 30 system has two sensors: a Proximity Sensor that uses a radar field to detect anyone leaning into the passenger compartment, and a Magnetic Resonance Sensor that detects intrusion-related vibrations and impacts. For an even greater level of security, consider Clifford Electronics optional sensors: OmniSensor (a digital analysis vibration/impact sensor) and/or the Glass Tampering Sensor (which detects attempts to break any of the vehicle's windows). Smart AutoTesting™ Each time you remotely arm your Concept 30, it will perform a series of tests on all triggers and sensors. If the hood or trunk is open when you arm the system, your Concept 30 will immediately alert you of the problem by issuing 4 chirps and 4 parking light flashes instead of the usual 2 and 2. If one of the sensors is malfunctioning, you will receive the usual 2 chirps and flashes, then, 5 seconds later, there will be 4 chirps and 4 flashes. NOTE: Since this is a warning indication, you will hear the 4 chirps even if you have the chirp muting feature turned on. Specific malfunction identification: The system can also indicate the specific malfunctioning trigger or sensor. This saves you time and money since your installer won't have to spend hours trying to determine where the problem is. Here's how it works, if you receive the 4-chirp/4-flash signal upon disarming: 1. When you insert your key and turn on the ignition, the LED indicator inside the vehicle will be flashing, pause, then repeat. 2. Count the number of blinks in one cycle between pauses (for your convenience, the blink cycle repeats 5 times) and refer to the chart below: Number of LED blinks between pauses Malfunction 1 blink 2 blinks 4 blinks 5 blinks Magnetic Resonance Sensor Proximity Sensor Trunk trigger Hood trigger 12