Clifford Concept 400 Owners Guide - Page 12

Table of User-Selectable Features Feature Select 1 blank press 2 blank presses 3 blank presses 4 blank presses 1 ✱ press Add master remote control NOTE 1 Chirps: off/loud/quiet (1/2/3 chirps) AutoArming: off/on NOTE 5 - Add companion remote: arm/disarm (1 then 2 chirps) 2 ✱ presses Personalized Siren Sounds** NOTE 2 NOT USED Lock upon AutoArming: off/on NOTE 6 - Add companion remote: trunk release* (2 chirps) 3 ✱ presses Play Personalized Siren Sounds**: trigger only/always (1/2 chirps) Valet mode entry/exit via the remote control: off/on AutoArming entry delay: off/on NOTE 6 - Add companion remote: silent arm and disarm (3 chirps) 4 ✱ presses Siren duration: 30/60/90sec.** AutoStart*: both off/both on/temp (1/2/3 chirps) only/battery only (1/2/3/4 chirps) FACT: off/on NOTE 6 - Add companion remote: timed headlight activation* (4 chirps) 5 ✱ presses AutoLock: off/on BlackJax anti-carjacking: off/on NOT USED NOTE 6 - Add companion remote: remote engine starting* (5 chirps) 6 ✱ presses AutoUnLock: off/on Clear all remotes NOTE 3 NOT USED NOTE 6 - Add companion remote: window rolldown/venting* (6 chirps) 7 ✱ presses Reset all features (except remotes Set a new valet/disarming PIN code and valet code) to factory settings NOTE 4 NOT USED NOTE 6 - Add companion remote: remote valet mode (7 chirps) * Requires optional wiring or accessory; ask your Clifford Dealer for details. ** Not available on European models due to EC regulations NOTE 1: Press button 1 of the new MASTER 5-button remote control. You will hear one chirp. Immediately press button 1 again. You will hear two chirps to confirm that the new remote control has been added. NOTE 2: Selection of this feature will cause the system to sound a few seconds of siren sound #1. Press the blank button to turn on this sound or the ✱ button to turn it off. The system will then sound a few seconds of sound #2. Repeat: blank=ON, ✱=OFF for each of the six sounds. NOTE 3: You'll hear two chirps to indicate all remotes have been cleared from memory. You must now add new/existing remotes with the "Add master remote control" feature and/or the "Other vehicle's remote" feature. NOTE 4: Immediately PRESS THE BLANK BUTTON, THEN enter your new code, wait for the two chirps, then turn off the ignition (you'll hear 3 chirps to confirm program mode exit). You MUST now turn the ignition back on and then re-enter your new PIN code. If the LED flashes on, your new code has been accepted. If the LED does not light, the two codes did not match and the system has reverted to your previous code. NOTE 5: Lets you arm/disarm with a new companion remote control or ANY remote (including 5-button master type) of a Clifford G4 system on your other vehicle(s). For instance, to set button ✱ of the other car's companion remote to arm and disarm your Concept 400, select column 4, row 1, then press button ✱ of the other vehicle's remote (you'll hear one chirp). Immediately press button ✱ a second time (you will hear a 2-chirp confirmation). Button ✱ of the other vehicle's remote will now arm/disarm your Concept 400 on this vehicle. NOTE 6: The features in this column allow you to control your system with the remote control of a G4 system on your other vehicle(s). Just select the function you wish, then press the unused button or button combination on the other remote that you want to use to perform that function on this system (you will then hear the chirps noted). NOTE: You must first set a button or button combination on the other car's remote that will arm/disarm the system (column 4, row 1) before these others will be accepted. Lifetime limited factory warranty terms & conditions Clifford vehicle security systems and accessories require professional installation by an Authorized Clifford Dealer. Unless the system is sold and installed by an Authorized Clifford Dealer, all product warranties and guarantees are void. (UK: This does not affect your statutory rights.) As the manufacturer, Clifford Electronics warrants to the original consumer purchaser, the system control unit and remote controls to be free from defects in material and workmanship for as long as you own the vehicle in which the system was originally installed. All other parts of the system and accessories to the system are warranted to be free from defects in material and workmanship for one (1) year from the date of purchase. Clifford Electronics will repair or replace, at its option and free of charge during the warranty period, any system component that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to our factory by an Authorized Clifford Dealer, transportation charges prepaid. Products returned to our factory must be accompanied by a photocopy of the purchase receipt. In the absence of such purchase receipt, the warranty period shall be one (1) year from the date of manufacture. Any damage to the product(s) as a result of misuse, abuse, neglect, accident, incorrect wiring, improper installation, destruction or alteration of the serial number, repair or alteration outside our factory, or any use violative of instructions furnished by us will void the warranty. This warranty is limited to defective parts and specifically excludes any incidental or consequential damages connected therewith. This warranty is not transferable. Clifford Electronics makes no warranty against theft. This warranty is not to be construed as an insurance policy against loss. Warranty on installation labor, removal and reinstallation charges are not the responsibility of Clifford Electronics, Inc.