Cobra MR HH150 FLT MR HH150 FLTE Manual - International - Page 13

Advanced Operation VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation Customer Memory Location Mode Assistance Warranty Your radio has ten memory locations (numbered 0 to 9) for your most frequently used FcLhOannAelTs.ITNheGse meMmoAryRloIcNatiEons cHanHbe1s5ele0cted individually or can be scanned. MEM/ESC Button Installation ESC Secondary Icons To Customer Assistance enter Memory mode, press Memory/Escape button. The display willSshEoTwUthPe MEM icon and the Memory Channel bank will be activated and displayed. PWR MEM H-MT-Lo ProgramEMNeTmEoRry Locations: 1. Press and hold the Memory/Escape button for Notice Caution two sWearcniongnds. The memory location number CHANNEL will start flashing. SC/DW Memory Location Number 2. Use the C1h6an+nel Up and Channel Down buttons to advance to the memory location (0-9) you want to program. 3. Press the Memory/Escape button to select the FLOVOATLING MARINE HH150 memVorOy Llo+cation. The memory channel number will stop flashing and the channel number will ESC SETUPstart flashing. PWR MEM SUHB-MM-L ERSENITBE4R.LUEse the Channel Up and Channel Down buttons Channel Up/Down Buttons to change to the channel you want to store into the CHANNEL selected memory location. SC/DW 16+ 5. Press the Memory/Escape button to program that channel. The memory location number will flash again. VOL VOL+ Repeat steps 2 through 5 to program as many additional memory locations as you want [up to ten VHF memory SUBMERSIBLE channels]. Channel Number 6. Press and hold the Memory/Escape button for two seconds. This will return the radio to Memory mode. 7. Press and release the Memory/Escape button again to return to Marine Standby mode. VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation MEM Icon Secondary Icons Installation Advanced Operation Customer Warranty To Assistance Recall a Stored Memory Location: 1.Press the Memory/Escape button. The MEM icon will be turned On. 2. Customer Assistance Press the Channel Up or Channel Down button to select the memory location. If a memory location has been programmed, its associated channel will display on the LCD. Your radio is now in Marine Standby mode on the selected memory location. Notice To Caution ExitWMarneinmg ory Location Mode: Press the Memory/Escape button to return the radio to Marine Standby mode. The last channel used in Marine Standby mode will now be displayed on the LCD and the MEM icon will disappear. To Erase Stored Memory Locations: 1. Press and hold the Memory/Escape button for two seconds. The memory location number will start flashing and the MEM icon will be turned On. 2. Use the Channel Up and Channel Down buttons to advance to the memory location you want to erase. 3. Press the Memory/Escape button to select the memory location. The memory channel number will stop flashing and the channel number will start flashing. 4. Use the Channel Up and Channel Down buttons to change the channel to read "--" at the selected memory location. 5. Press the Memory/Escape button to erase that memory location. Repeat steps 2 through 5 to erase as many additional memory locations as you want. 6. Press and hold the Memory/Escape button for two seconds. This will return the radio to Memory mode. 7. P ress and release the Memory/Escape button again to return to Marine Standby mode. 20 English Nothing Comes Close to a Cobra® 21