Cobra MR HH150 FLT MR HH150 FLTE Manual - International - Page 14

Main Icons VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation Advanced Operation Customer Assistance Warranty Memory Location Scan Memory Location Scan Mode Intro Operation DuCArsuissnitsotgmanecrMe emoWarryrantLy ocation Scan mode, the radio will rapidly Installation sCAcsuassitsnotmantechrerough all programmed memory channels. Whenever any activity is detected on a channel, the radio will stop the Secondary Icons Installation scaCunstofmoerr 10 seconds to allow you to listen briefly on that chaAsnsisntaencle. It will then continue to scan unless you switch out of Secondary Icons Memory Location Scan mode. Notice Notice NCOaTutiEon Warning If there are fewer than two memory locations programmed in tChauetionradio, WtharneingMemory Location Scan option will not be available. At least two memory locations need to be programmed to use the Scan button. FLOATING MARITNo EEnter MHemHo1ry5Lo0cation Scan: MEM/ESC Button 1. From Marine Standby mode, press the Memory/Escape button. EFSLCOATING 2. MPresAs RanIdNhoSEldEthTeHUDHUPA1L W5A0TCH/SCAN button. The radio will immediately begin to scan all pre-assigned PWR MEM ESCH-Mmt-hLeemLCorDy. chanEnNelTs.ETRhe SCAN and SETUP MEM icons will show on 3. A signal on any channel will stop the scan for PWR Scan Button SC/DW CHMAENMNEL 10 on tsheacHtoln-oMdcsa-ttiL1oon6a.l+low youEtNo TlisEteRn to the traffic 4. Press the Channel Up or Channel Down button SC/DW VOL CHtoAreNsNumEeLscanning the Memory Location Scan channels or to change t1he6+scan direction. 5. To EXIT MVeOmLo+ry Location Scan mode, press and hold the DUAL WATCH/SCAN button again. The SCAN and MEM icons will disappear from the LCD and the radio will return VOL to Memory mode. VOL+ SUBMERSIBLE SUBMERSIBLE VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation Advanced Operation Customer Assistance Warranty Scanning Channel Scan Mode During Channel Scan mode, the radio will rapidly switch FLOInstaAllatTionINGCAsussitsotmanefacMrrenoymAaccRhtiavIniNtnyeiElstdoectHehcatHnende1,lt5thhe0roruagdhio ALL will the channels. stop the scan Whenever for 10 Secondary Icons seconds to allow you to listen briefly on that channel. The ESC radio will then Channel Scan mcoondtein.uSe EtoTscUaPn unless you switch out of the PWR SCAN Button MEM To Notice Caution EntHeWr-aMrCninh-gaLnnel ScanE: NTER 1. F rom Marine Standby mode, press and hold the SC/DW CHADbNeUgANinLEtWLoAsTcCaHn /tShCeAeNntbiruettcohna. nTnheel radio will immediately map selected in the active channel m1a6p+. The SCAN icon will show on the LCD. VOL SCAN Icon 2. A signal on any channel will stop the scan for 10 seconds to alVloOwLy+ou to listen to the traffic on that location. 3. P ress the Channel Up or Channel Down button to resume scanning the Channel Scan channels SUBMEorRtoSchIaBngLeEthe scan direction. FLOATING MARINE HH1504. T o EXIT Channel Scan mode, press and hold the ESC SETUPDUAL WATCH/SCAN button again. The SCAN icon will disappear from the LCD and the radio will PWR MEM H-M-L Channel Up/Down Buttons ENTER return to Marine Standby mode. CHANNEL SC/DW 16+ VOL VOL+ SUBMERSIBLE 22 English Nothing Comes Close to a Cobra® 23