Cobra MR HH150 FLT MR HH150 FLTE Manual - International - Page 8
Common Radio Functions
View all Cobra MR HH150 FLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation Getting Started MR HH150FLT Radio Secondary Icons Installation FLOATING MARINE HH150 PWR ESC MEM H-M-L SETUP Notice ENTER CHANNEL SC/DW 16+ VOL VOL+ SUBMERSIBLE Getting Started Customer Assistance Warranty • Refer to the foldout at the front of this manual to identify the various controls and indicators on your radio. Throughout this mCuasntomuearl you will be instructed to "Press" or to "Press and Assistance Hold" various buttons (except "Push to Talk") on the radio. "Press" means a momentary press of approximately one second. "Press and Hold" means to hold the button down for approximately three seconds. Whenever you press any button except the Talk button on yoCuaurtiornadio, aWbarrniiengf tone (beep) will sound to confirm the button press. With all button presses, the appropriate icon will appear on the LCD and the backlight will turn On. The backlight will stay On for 10 seconds after the button is released. At times, you will hear two other sounds. Two beeps will sound to confirm your setting changes and three beeps will sound to notify you of an error. Common Radio Functions The following procedure defines common operating functions of the radio when in Standby mode. Power On/Off Button Power Button Power On/Off Button The On/Off Button control is located at the front left side of the radio. Pressing and holding the power On/Off button for 3 FLOATING MARINE HH1s5e0conds will turn the radio On or Off. ESC SPEToUwP er Saver PWR MEM H-M-L SC/DW CHANNEL ENTER Your radio has a unique circuit designed to extend battery life. If16+ there are no transmissions, signals, or button presses for ten seconds, the radio will automatically switch to Power Save VOL VOLm+ ode. Signal reception or any button press will take the radio SUBMERSIBLE out of Power Save mode. Volume Control Volume is controlled by the Up/Down volume buttons. n To increase the volume, press the Volume + button. n To decrease the volume, press the Volume - button. 10 English VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation Speaker/Microphone Jack Secondary Icons Installation Getting Started Customer Warranty RAassdisitaoncSe peaker and Microphone The internal Radio Speaker and Microphone are located on the bottom front face of the radio below the lower control buttons. ACAnsussiotsotmpanetcrieonal Speaker/Microphone jack is located at the top of the radio. Flip the protective cap open and insert the plug into the jack. Talk Button Talk Button Notice PrCeaustisonand hoWladrnitnhg e Talk button to transmit messages. Release the Talk button to stop transmitting. If the Talk button is pressed while on a receive only channel, a three beep error signal will sound. Squelch Control Squelch Control This radio is equipped with an automatic squelch control. Squelch filters weak signals and radio frequency (RF) noise so you can hear the main signal clearly. To receive weak signals, the automatic squelch can be turned Off (opened) by pressing the Squelch Defeat button. You will likely hear a lot of static and RF noise along with the weak signal. Press the Squelch Defeat button for up to five seconds to briefly open squelch. To hold squelch open for longer periods, press and hold the Squelch Defeat button for more than five seconds. Squelch will remain open until you press the Squelch Defeat button again or you change channels. Nothing Comes Close to a Cobra® 11