Cobra MR HH450 MR HH450 DUAL Manual - English - Page 11

Introduction Included in this Package Intro Operation Customer Warranty Included in this Package Assistance • You should find all of the following items in the package with your Cobra VHF/GMRS radio: Installation Customer Assistance Radio Secondary Icons Drop-In Battery Charger AC Charger U ROGRVGHMFRS VOX TX HI SAME MEM Notice Caution Warning DC Charger LiON Battery Pack For connection to 120-volt power source. Antenna For connection to 12-volt power sources. Operating Instruction Manual Spring-Loaded Belt Clip Wrist Strap Alkaline Battery Tray Introduction Install/Remove Antenna Intro Operation Customer Warranty Install/Remove Antenna Assistance • Antenna 1. To install the antenna turn the antenna into the radio Main Icons clockwise to tighten. Do not overtighten. In2st.allTatoionremoCAvsuessitsottmahnecere antenna turn the antenna counterclockwise. Secondary Icons This radio transmitter IC: 906A-MRHH450 has been approved by Industry Canada to operate with the supplied antenna. Other antennas are strictly prohibited for use with this device. Cet émetteur radio IC: 906A-MRHH450 a été approuvé par Intro Operation Customer WINnaordrtaicunetsy trie CaCanuatiodna pour Wfoarnicngtionner avec l'antenne fournie. Assistance D'autres antennes sont strictement interdits pour une utilisation avec cet appareil. Batteries Installation and Charger Customer Assistance The radio is shipped with a sealed lithium-ion (LiON) battery • pack SecondaLryiOIcoNnsBattery Pack (P/N CM 110-026) that is rechargeable. WARNING The charger provided for this radio is only to be used Notice Caution Warning to charge the battery pack provided. Do not charge any other type of batteries in the charger as fire, explosion or battery damage will occur. Avoiding extreme temperatures will also help prolong the life of the battery pack for the radio. Install Battery Pack When your rechargeable batteries begin to discharge too quickly, it is time to install a new battery pack. Your radio will also operate with five (5) high-quality AA alkaline batteries, using the included alkaline battery tray. Tighten Screw Installing the Battery Pack 1. Position the battery pack over the back of the radio. 2. Engage the battery pack into the radio by sliding to the top until battery pack is fully seated against radio housing. 3. Tighten the screw using the end of the belt clip to secure the battery pack to the radio. Do not overtighten. Only use the end of the belt clip to tighten the screw. 16 English Nothing Comes Close to a Cobra® 17