Compaq ProLiant 1000 Memory technology evolution: an overview of system memory - Page 11

Advanced memory technologies Despite the performance improvement in the overall system due to use of SDRAM, the growing performance gap between the memory and processor must be filled by more advanced memory technologies. These technologies, which are described on the following pages, boost the overall performance of systems using the latest high-speed processors (Figure 9). Figure 9. Peak bandwidth comparison of SDRAM and advanced SDRAM technologies Double Data Rate SDRAM technologies Double Data Rate (DDR) SDRAM is advantageous for systems that require higher bandwidth than can be obtained using SDRAM. Basically, DDR SDRAM doubles the transfer rate without increasing the frequency of the memory clock. This section describes three generations of DDR SDRAM technology. DDR-1 To develop the first generation of DDR SDRAM (DDR-1), designers made enhancements to the SDRAM core to increase the data rate. These enhancements include prefetching, double transition clocking, strobe-based data bus, and SSTL_2 low voltage signaling. At 400 MHz, DDR increases memory bandwidth to 3.2 GB/s, which is 400 percent more than original SDRAM. Prefetching In SDRAM, one bit per clock cycle is transferred from the memory cell array to the input/output (I/O) buffer or data queue (DQ). The I/O buffer releases one bit to the bus per pin and clock cycle (on the rising edge of the clock signal). To double the data rate, DDR SDRAM uses a technique called prefetching to transfer two bits from the memory cell array to the I/O buffer in two separate pipelines. Then the I/O buffer releases the bits in the order of the queue on the same output line. This is known as a 2n-prefetch architecture because the two data bits are fetched from the memory cell array before they are released to the bus in a time multiplexed manner. 11