Craftsman 17541 Operation Manual - Page 23

INTERNAL ROUTING (Figs. 11, 11a, 11b and 12) 1., With depth-of-cut set, tilt router and place on workpiece with leading edge of sub-base contacting workpiece first (Fig. 11)_ 2. Turn motor "On" and let motor build up to its full speed, being careful not to let cutter bit contact workpiece. 3. To begin your cut, gradually feed the cutter bit into the workpiece until the subbase is level with the workpiece (see Fig 11 a, 11 b). 4. When cut is completed, turn motor "Off' and let cutter bit come to a complete stop before removing it from the workpiece. 5. Unplug router from power source, place router upside down on worktable, and inspect finished cut in workpiece. Fig, 11 Fig. 12 Feed Direction Edge Guide Fig. 11a Fig. 11b Feed Direction-_ Internal sloting on workpiece with fixed base on the router base with BOTH HANDS at all times, Failure to do so could result in I lozs_s WofAcRonNtIrNolGc: ausAinlgwaypsosssiebcluereslyericoluasmppeyrosuornawl oinrkjuprieyc, eif aunsdingkeaeproautfeirrmtagbrleip, • large cutter bits should be used for edging only, z_ WARNING: Removing cutter bit from workpiece while it is still rotating could damage workpiece and result in loss of control, causing serious personal injury. 23