Craftsman 25980 User Instructions - Page 1

Model No. 25980 ACCU-RIP SAW GUIDE USER INSTRUCTIONS About the Accu-Rip Saw Guide The Accu-Rip is designed as an accessory for use with most circular power saws. It will only work with circular saws that contain Right-Hand Blades. When used properly, the Accu-Rip will improve the accuracy of long, straight cuts in any material that you would normally cut with your saw. The Accu-Rip also eliminates several time consuming steps normally needed when using a circular saw to make straight rip-cuts to a specific width: § Eliminates the need for a tape measure § Eliminates 'marking' the material § Eliminates the use of chalk lines § Because the Cut-Guide follows the edge of your material, you no longer need to carefully follow a line on the material. § Allows you to change cutting widths in seconds by simply adjusting the CutGuide. You can use the Accu-Rip to make straight rip cuts as narrow as 1/16 inch, or as wide as 24 inches for splitting 48-inch material such as plywood, wafer board, paneling, or siding. The design of the Accu-Rip allows adjustment to fit most current brands of saws. It has been tested with the current major brands of Right-Hand Blade circular saws. If you have an older circular saw, the Accu-Rip may not fit properly into the saw base plate. Please read carefully all sections of this User Guide. The Operator Tips section gives useful information on ways to make your Accu-Rip perform at its best. Important Safety Information Please Read Carefully § Always unplug your saw from the power source before attaching or removing the Accu-Rip. § The Accu-Rip is designed to fit RightHand Blade circular saws only. Never attempt to use the Accu-Rip with other types of saws. § When attaching the Accu-Rip to your circular saw, make sure that the LBrackets and T-Bolts are located in areas that do not interfere with the saw's normal operation. § When using the Accu-Rip, periodically re-tighten the T-Bolts. § Follow the User instructions when adjusting, attaching, or using the AccuRip. § Always follow the saw manufacturer's safety guidelines when operating or maintaining your saw. § Keep hands away from saw blade when operating your saw. § Always wear proper eye protection when operating your saw. 1