Craftsman 95355 User Guide - Page 3

Step 4 Program to Opener NOTE: The unit must have an enrolled user before it can be programmed to the opener. Due to the 30 second time interval, a second person may be needed to press the "learn" button. If there is no purple "learn" button refer to Troubleshooting. 1. Press and release the purple "learn" button on the motor unit of the garage door opener. See illustration above. 2. Open cover and wait for Ready LED to light. 3. Within 30 seconds of pressing the "learn" button, slowly and firmly swipe enrolled finger. NOTE: The Retry LED will light if another swipe is needed. Step 5 Operation 1. Open cover and wait until Ready LED is lit. 1 JIh fll _qIoihdlII1_° 2. Swipe finger slowly and firmly down the sensor strip. o 3. The Pass LED will flash and garage door will either open or close. NOTE: If cover is already open, press either the Resend or the Enroll button to turn unit on. The Fail or Retry LED will light if another swipe is needed. If this occurs, swipe slowly and with more pressure. It may require multiple swipes to get a passed swipe. While the door is traveling the Send LED will be lit. During this time the only way to reverse or stop the door is to press the Resend button. 4. After a passed swipe the Pass LED will light followed by a lit Send LED. The opener lights will flash. Programming is complete. 5. If the opener lights don't flash, press and release the Resend button at 1 second intervals for up to 5 seconds until the opener lights flash or the door moves. Programming is complete. NOTE: If unit will not program to opener repeat the steps above or refer to Troubleshooting.