Craftsman 95355 User Guide - Page 4
Erase/Reset, Battery, Troubleshooting
UPC - 012381535552
View all Craftsman 95355 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Erase/Reset • To erase users: NOTE: Erasing a user will erase ALL stored fingerprints. User does NOT need to reprogram to opener. 1. Open cover and wait until Ready LED is lit. 2. Enrolled user must slowly and firmly swipe fingerprint. 3. Press and hold the Enroll button for at least 6 seconds. The Pass LED and Fail LED will flash for 15 seconds. During this time the Resend button is active. After 15 seconds the Enroll and Ready LEDs will light indicating fingerprints are erased. The unit will return to Enroll mode. • To return unit to Factory Reset state: NOTE: Factory reset state will erase ALL stored fingerprints. This method should be used ONLY when an enrolled user is not available as it requires user to reprogram unit to opener. 1. Open cover and wait until Ready LED is lit. 2. Press and hold the Enroll button until all LEDs turn off. Release button. 3. Again press and hold the Enroll button until the Ready and Enroll LEDs are lit and not flashing. • If finger is enrolled but unit will not program to opener: -- Ensure that the opener has a purple "learn" button. If opener does not have a purple "learn" button it is not compatible with the EntryEase unit. • If the unit is in Enroll mode at power up: -- Complete enrollment process for initial user. -- The initial enroll process failed (signalled by a lit Enroll LED and Fail LED) and must be repeated. • If enrolling new user and all LEDs flash and unit returns to Ready mode: -- The memory is full. In order to add new user, the memory needs to be erased. Refer to Erase User or Factory Reset. • If the unit does not wake: -- A button may be stuck. Press Enroll and Resend buttons to ensure free movement. -- The batteries may need to be replaced. • If the Fail LED flashes during use: -- The batteries need to be replaced. NOTE: If sensor is dirty, user should wipe sensor with a clean finger. It is recommended that the sensor be periodically cleaned with a lint-free cloth dampened with alcohol The Battery To prevent possible SERIOUSINJURYor DEATH: • NEVERallow small children near batteries. • If battery is swallowed, immediately notify doctor. The batteries should produce power for at least one year. Replace when the Fail LED flashes during use. The unit requires 4 AAA batteries. Dispose of old batteries properly. 1. Slide cover completely off. 2. Unscrew the two screws and remove the battery cover. 3. Replace the batteries. Screw the battery cover back on. 4. Slide entry cover back into place. Troubleshooting • If no known enrolled users are available: -- The memory must be erased using the Factory Reset process. • If the unit does not recognize a swiped fingerprint: -- Ensure that the Ready LED is lit before you swipe. -- Ensure that fingerprint is swiped correctly (See Tips for Success). -- Ensure that fingerprint is enrolled. -- Ensure that sufficient pressure is being applied to sensor strip (do not press too hard). -- Ensure that the sensor and finger are not wet. I RUenpit laccoevmeren.t.....p...a..r.t.s FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-4-MY-HOME ®(1-800-469-4663) 41A579 I