Cub Cadet CC 310 Operation Manual - Page 6
Assembly
View all Cub Cadet CC 310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY INSTALLING AND ADJUSTING THE HANDLE Installing the Handle 1. Push the handle down onto the shaft housing (Fig. 1). The bolt hole in the handle should be to the right. 2. Insert the bolt into the bolt hole and push it through (Fig. 1). Tighten the bolt with a 3/8" socket, but do not tighten the bolt completely. 3. While holding the unit in the operating position, move the handle to the location that provides the best grip. Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip (Fig. 1). 4. Tighten the bolt with a 3/8" socket until the handle is secure. Adjusting the Handle If the handle requires adjustment: 1. Loosen the bolt with a 3/8" socket (Fig. 1). 2. While holding the unit in the operating position, move the handle to the location that provides the best grip. Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip (Fig. 1). 3. Tighten the bolt with a 3/8" socket until the handle is secure. Shaft Grip Minimum 6 in. (15.24 cm) Bolt Fig. 1 Handle Shaft Housing 6