Cub Cadet Pro Z 160L EFI Owners Manual - Page 24

Replacing the Belt 1. Remove the deck from beneath the tractor. Refer to Deck Removal. 2. Remove the wing knobs securing the belt covers to the deck. See Figure 4-18. (a) (b) (a) 5. Install the new belt around the spindle pulleys as shown and reinstall the belt covers. See Figure 4-20. 2. Use a 1-1/8" wrench to hold the hex nut on top of the spindle assembly when loosening the bolt securing the blade. A block of wood may be placed between the deck housing and the cutting edge of the blade to help in breaking loose the hex nut securing the blade. See Figure 4-21. Figure 4-18 3. Remove the two idler pulleys (a) by removing the flange lock nuts (b) and pulley caps (c) that secure them to the deck and the idler arm. See Figure 4-19. Do not lose any of the hardware when removing the flange lock nuts (b). (b) (c) (a) (b) (c) (a) Figure 4-19 NOTE: Take note of the position of the belt guards to ensure they are properly re-installed. 4. Remove the belt from the spindle pulleys. Figure 4-20 6. Place the belt around the idler pulleys removed in step 3 with the "V" side facing in. Once in place, reinstall all the hardware and tighten the flange lock nut to secure the assembly. See Figure 4-18. 7. Route the belt as shown in Figure 4-18 and then reinstall the deck. Refer to "Deck Installation" on page 23. Mower Blade Care WARNING! Before performing any maintenance, place the PTO switch in the "OFF" position, engage the parking brake lever, turn the ignition key to the "OFF" position and remove the key from the switch. Protect your hands by using heavy gloves when handling the blades. When servicing the mower deck, be careful not to cut yourself on the sharpened blades. The cutting blades must be kept sharp at all times. Sharpen the cutting edges of the blades evenly so that the blades remain balanced and the same angle of sharpness is maintained. If the cutting edge of a blade has already been sharpened many times, or if any metal separation is present, it is recommended that new blades be installed. New blades are available at your authorized dealer. The blades may be removed as follows. 1. Remove the deck from beneath the tractor, (refer to "Deck Removal" on page 22) then gently flip the deck over to expose its underside. Figure 4-21 3. When reinstalling the blades, be sure they are installed so that the wings are pointing upward toward the top of the deck. 4. Tighten the blade nuts to 70-90 ft. lbs. 5. Reinstall the deck. Refer to "Deck Installation" on page 23. Changing the Transmission Drive Belt Several components must be removed and special tools used in order to change the tractor's transmission drive belt. See your Cub Cadet dealer to have the transmission drive belt replaced. Tractor Creeping Creeping is the slight forward or backward movement of the mower when the throttle is on and the speed control levers are in the neutral position. If your mower creeps, see an authorized service dealer. 24 Section 4- Service