Cub Cadet TANK LZ 54 TANK LZ 48 Operator's Manual - Page 15
Controls & Features
View all Cub Cadet TANK LZ 54 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Controls & Features 4 Deck Lift Pedal RH & LH Drive Control Levers Deck Height Index Seat Adjustment Lever Deck Lift Release Lever Parking Break Lever Digital Tachometer & Hour Meter Ignition Switch Tool Box Throttle Control PTO Switch Cup Holder Fuel Gauge Choke Knob Accessory Switch Receptacles Fuel Gauge Fuel Tank Cap Fuel Tank Cap Figure 4-1 NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that Ignition Switch position on the tractor when facing forward while seated in the operator's seat. The ignition switch is located on the LH console RH and LH Drive Control Levers to the right of the operator's seat. The ignition switch has three positions as follows: The RH and LH control levers are located on each side of the operator's seat. These hinged levers pivot outward to open space to permit the operator to either sit in the tractor seat, or to dismount the tractor. The levers must be fully opened out and in the neutral position to start the tractor engine. Each lever controls the respective RH or LH transmission. These levers control all of the movements of the tractor. Driving and steering utilizing these control levers is quite different from conventional tractors, and will take some practice to master. Refer to Operation for instructions on using the control levers. STOP - The engine and electrical system is turned off. RUN - The tractor electrical system is energized. START - The starter motor will turn over the engine. Release the key immediately when the engine starts NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use. 15