D-Link DSN-2100-10 User's Manual for DSN-2100-10 Valid for firmware - Page 73

5.4.3.4 Deleting LAGs If you no longer need a LAG, use the following procedure to delete it. A warning message does not appear before you delete a LAG. Therefore, be sure you do not need the LAG before you delete it. 1. In the Logical Resources tab, click the LAG you want to delete. 2. Perform one of the following steps to delete the selected LAG: - On the Storage menu, click Delete LAG. - Right-click and click Delete LAG. 5.4.4 Working with Network Portals The network portal is the physical Ethernet port attached to the host. Before you create a network portal, you must assign an IP address for the network portal and an IP address for the iSCSI initiator (if more than one iSCSI initiator will access this network portal, each initiator needs its own IP address). The initiator(s) and the network portal must have different IP addresses, yet reside on the same subnet. 5.4.4.1 Creating Network Portals The following procedure describes how to create network portals. When you create a network portal, you specify the IP address for each xStack Storage Array data port that will be communicating with your iSCSI initiator. As you create network portals, record the information in Appendix B. Your iSCSI initiator(s) must be aware of the IP address(es) you specify in this procedure so it can communicate with the target xStack Storage Array. 1. In the Logical Resources tab, click the plus sign next to Target Resources. 2. Click the plus sign next to Network Entities. 3. Click the plus sign next to LAG Resources. 4. Under LAG Resources, click a LAG. 5. Perform one of the following steps: - On the Network menu, click Create Network Portal. - In the Logical Resources tab, right-click a LAG and click Create Network Port. Either step starts the Create Network Portal Wizard and displays the Set the IP Address screen (see Figure 5-25). xStack Storage User's Guide 73