Dacor CM24 Installation Instruction - Automatic Coffee System - Page 11
Nstalling, Offee, Ystem, Abinet, Erifying, Peration, Emove
View all Dacor CM24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Instructions Installing the Coffee System in the Cabinet • While supporting the coffee system from below, insert it into the cabinet cutout. As you insert it into the cabinet, line up the glides on the appliance with the cabinet glides. The system should glide on the rails when slight pressure is applied to the front of the coffee system. If it does not glide smoothly, check the distance between the glides again. See page 8. • As you slide the coffee system into the cabinet the locking tab on the glides will engage. Locking Tab Locking Tab Location If You Need to Remove the Coffee System From the Cabinet Should the coffee system need to be removed from its location: • Disconnect the power plug from the power receptacle. • Press the respective locking tabs on the glides and remove the appliance, supporting it from below. Verifying Operation CAUTION Pour only roasted, unflavored coffee into the coffee bean container. Any other kind of coffee, e.g. coffee which has already been ground, will damage the grinder. • Plug the coffee system into the dedicated, properly grounded, 3-prong receptacle. • Turn the light on and off to test it. • Turn on the power switch, located below the control panel. • On model CM24P (plumbed model): turn on the water supply at the shut-off valve. Check to make sure the pressure regulator is set between 1.5 bars to 3 bars pressure. Adjust the regulator if necessary. • On model CM24T (tank model): Fill the tank with filtered water (4 gpg maximum water hardness, do not use distilled water). • Push the hot water button. Wait about six seconds. • Continue to push the hot water button every six seconds until air bubbles no longer come out of the dispenser and about six ounces of water is dispensed. • Clean the coffee system according to the Routine Cleaning and Milk Cleaning instructions in the use and care manual. On model CM24T, clean the water tank. • Put a sauce pan under the drink dispenser. • Make one of each type of drink in the Basic Operation Instructions section of the use and care manual. If the coffee system does not operate properly, follow these troubleshooting steps: 1. Verify that power and water are being supplied to the coffee system. On CM24T, make sure the water tank is full. 2. Make sure that the coffee bins have been properly filled according to the Basic Operating Instructions in the use and care manual. 3. Check the regulator to make sure it is properly adjusted. Air in the system during initial operation can cause the initial adjustment to be incorrect. 4. Make sure that water flows through the pressure regulator in the right direction. 5. Repeat the above test. 6. If the appliance still does not work, contact an authorized Dacor ® service company. If you are unable to locate a Dacor Service company, please contact Dacor at (800) 793-0093, or visit us on the web at www.Dacor.com. Do not attempt to repair the appliance yourself. Dacor is not responsible for service required to correct a faulty installation.