Dacor CM24 Installation Instruction - Automatic Coffee System - Page 9
Pressure Regulator Adjustment
View all Dacor CM24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation Instructions • Cut a section of the supplied Ø 4mm (5/32") Teflon hose long enough to connect between the coffee system water inlet quick release fitting and the regulator without binding or kinking. • Insert one end of the Teflon hose (Ø 4mm) into the quick-release fitting on the appliance. Then pull it out slightly to make sure that it is secure. • Connect the hose connected to the appliance to the output of the regulator. Pay attention to the flow direction arrows on the pressure regulator. IMPORTANT: If you connect the hoses to the regulator backwards, the water will not flow into the coffee system and it will not work. • Insert the end of the second hose into the input on the regulator. • Attach the third quick-release fitting to the second hose. • With the main water valve closed, attach the quick- release fitting to the water line from decalcification kit. You can connect to a house water supply hose or water line using a hose fitting (not supplied) that connects to the 1/4-19 BSPP male thread on the quick release connector. Coffee System Water Inlet Quick Release Connector from regulator Hose Fitting (not supplied) Pressure Regulator Adjustment IMPORTANT: The water pressure at the output of the pressure regulator may not exceed 3.0 bars/43.5 psi (1.5 bars/21.8 psi minimum). To adjust the output, pull the pressure regulator control knob up slightly. Turn it clockwise to increase the output pressure. Turn it counter-clockwise to reduce the pressure. After adjustment, gently push the control button back in. Quick-Release Fitting Control Knob Pressure Regulator Adjustment