Dell Alienware Area 51 R2 Service Manual - Page 61
Replacing the Drive-Bay Heat-Sensor, Procedure, Post-requisites
View all Dell Alienware Area 51 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Replacing the Drive-Bay Heat-Sensor WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/regulatory_compliance. Procedure 1 Reroute the drive-bay heat-sensor in the sensor bracket. 2 Align the drive-bay heat-sensor in the securing clip. 3 Close and press the release tab on the securing clip. 4 Lay the chassis on the left side. 5 Connect the drive-bay heat-sensor cable to the connector on the system board. See "System Board Components". Post-requisites 1 Replace both the left and right side-panels. See "Replacing the Side Panels". 2 Replace the stability foot. 61