Dell Alienware M11x R3 Service Manual - Page 15

Replacing the Display Assembly

Get Dell Alienware M11x R3 PDF manuals and user guides View all Dell Alienware M11x R3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

13. Remove the four screws that secure the display assembly to the computer base. 1 screws (4) 2 display cable connector 14. Gently slide the Mini-Card antenna cables out through the slot on the computer base. 1 Mini-Card antenna cables 15. Lift the display assembly off the computer. Replacing the Display Assembly 1. Follow the instructions in Before You Begin. 2. Slide the antenna cables in through the slot on the computer base. 3. Place the display assembly in position and replace the four screws that secure the display assembly to the computer base. 4. Connect the display cable to the connector on the system board. 5. Turn the computer over and route the Mini-Card antenna cables through the routing guides on the computer base. 6. Connect the Mini-Card antenna cables to the Mini-Card(s). 7. Replace the palm rest assembly (see Replacing the Palm Rest Assembly). 8. Replace the keyboard (see Replacing the Keyboard). 9. Replace the hinge cover (see Replacing the Hinge Cover). 10. Replace the memory module(s) (see Replacing the Memory Module(s)). 11. Follow the instructions from step 6 to step 8 in Replacing the Hard Drive.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
13.
Remove the four screws that secure the display assembly to the computer base.
14.
Gently slide the Mini-Card antenna cables out through the slot on the computer base.
15.
Lift the display assembly off the computer.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Slide the antenna cables in through the slot on the computer base.
3.
Place the display assembly in position and replace the four screws that secure the display assembly to the computer base.
4.
Connect the display cable to the connector on the system board.
5.
Turn the computer over and route the Mini-Card antenna cables through the routing guides on the computer base.
6.
Connect the Mini-Card antenna cables to the Mini-Card(s).
7.
Replace the palm rest assembly (see
Replacing the Palm Rest Assembly
).
8.
Replace the keyboard (see
Replacing the Keyboard
).
9.
Replace the hinge cover (see
Replacing the Hinge Cover
).
10.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
11.
Follow the instructions from
step 6
to
step 8
in
Replacing the Hard Drive
.
1
screws (4)
2
display cable connector
1
Mini-Card antenna cables