Dell Inspiron 24 5410 All-in-One Service Manual - Page 32
Removing the M.2 2280 solid-state drive, Next steps, Prerequisites, About this task, Steps
View all Dell Inspiron 24 5410 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
3. Slide the solid-state drive into the M.2 card slot on the system board. 4. Replace the screw (M2x3.5) that secures the solid-state drive to the system board. Next steps 1. Install the system-board shield. 2. Install the I/O cover. 3. Install the back cover. 4. Install the stand. 5. Follow the procedure in After working inside your computer. Removing the M.2 2280 solid-state drive Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the stand. 3. Remove the back cover. 4. Remove the I/O cover. 5. Remove the system-board shield. About this task NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card configurations on the M.2 card slot are: ● M.2 2230 solid-state drive ● M.2 2280 solid-state drive NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive. The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure. Steps 1. Remove the screw (M2x3.5) that secures the solid-state drive to the system board. 2. Slide and remove the solid-state drive from the M.2 card slot on the system board. 32 Removing and installing components