Dell Inspiron 24 5410 All-in-One Service Manual - Page 58
Install the, Adhere the tape that secures the microphone cable to the display-assembly base.
View all Dell Inspiron 24 5410 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Steps 1. Align and place the microphone module into the slot on the display-assembly base. 2. Replace the four screws (M2X3.5) that secure the microphone module to the display-assembly base. 3. Route the microphone cable through the routing guides on the display-assembly base. 4. Adhere the tape that secures the microphone cable to the display-assembly base. Next steps 1. Install the system board. 2. Install the heat sink. 3. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable. 4. Install the wireless card. 5. Install the memory module. 6. Install the media-card reader. 7. Install the system-board shield. 8. Install the hard drive. 9. Install the I/O cover. 10. Install the back cover. 11. Install the stand. 12. Follow the procedure in After working inside your computer. 58 Removing and installing components