Dell Inspiron 24 5420 All-in-One Owners Manual - Page 57
Solid-state drive, Removing the M.2 2230 solid-state drive
View all Dell Inspiron 24 5420 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Steps 1. Align the screw holes on the hard drive with the screw holes on the hard-drive bracket. 2. Replace the four screws (M3x3.5) that secure the hard-drive bracket to the hard drive. 3. Slide the hard-drive assembly into the slot on the display-assembly base. 4. Replace the screw (M3x5) that secures the hard-drive assembly to the display-assembly base. Next steps 1. Install the back cover. 2. Install the stand. 3. Follow the procedure in After working inside your computer. Solid-state drive Removing the M.2 2230 solid-state drive Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the stand. 3. Remove the back cover. 4. Remove the I/O cover. 5. Remove the system-board shield. About this task NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card configurations on the M.2 card slot are: ● M.2 2230 solid-state drive ● M.2 2280 solid-state drive NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive. Removing and installing Customer Replaceable Units (CRUs) 57