Dell Inspiron 24 5420 All-in-One Owners Manual - Page 83
System board, Removing the system board
View all Dell Inspiron 24 5420 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
System board Removing the system board CAUTION: The information in this section is intended for authorized service technicians only. Prerequisites 1. Follow the procedure in Before working inside your computer. NOTE: Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board. NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board. NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you can reconnect the cables correctly after you replace the system board. 2. Remove the stand. 3. Remove the back cover. 4. Remove the I/O cover. 5. Remove the hard drive. 6. Remove the system-board shield. 7. Remove the memory module. 8. Remove the wireless card. 9. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable. 10. Remove the integrated heat sink or discrete heat sink About this task The following image indicates the connectors on your system board. Removing and installing Field Replaceable Units (FRUs) 83