Dell Inspiron Mini 1018 Service Manual - Page 14

Display Panel

Page 14 highlights

1 screws (2) 3 display bezel 2 rubber pads (2) 5. Using your fingertips, carefully pry up the inside edge of the display bezel. 6. Lift the display bezel off the display assembly. Replacing the Display Bezel 1. Follow the instructions in Before You Begin. 2. Align the display bezel over the display panel, and gently snap it into place. 3. Replace the two screws that secure the display bezel to the display back cover. 4. Replace the two rubber pads that cover the display bezel screws. 5. Replace the display assembly (see Replacing the Display Assembly). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer. Display Panel Removing the Display Panel 1. Follow the instructions in Before You Begin. 2. Remove the display assembly (see Removing the Display Assembly). 3. Remove the display bezel (see Removing the Display Bezel). 4. Disconnect the camera cable from the connector on the camera module. 5. Remove the four screws that secure the display panel to the display back cover. 6. Lift the display panel off the display back cover.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46

5.
Using your fingertips, carefully pry up the inside edge of the display bezel.
6.
Lift the display bezel off the display assembly.
Replacing the Display Bezel
1.
Follow the instructions in
Before You Begin
.
2.
Align the display bezel over the display panel, and gently snap it into place.
3.
Replace the two screws that secure the display bezel to the display back cover.
4.
Replace the two rubber pads that cover the display bezel screws.
5.
Replace the display assembly (see
Replacing the Display Assembly
).
Display Panel
Removing the Display Panel
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Disconnect the camera cable from the connector on the camera module.
5.
Remove the four screws that secure the display panel to the display back cover.
6.
Lift the display panel off the display back cover.
1
screws (2)
2
rubber pads (2)
3
display bezel
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.