Dell PowerConnect W-IAP3WN Dell Instant 5.0.3.0-1.1.0.0 User Guide - Page 93

Table 10 Network Service Options (Continued) Service Description smb-tcp smb-udp smtp snmp snmp-trap svp tftp Server Message Block-Transmission Control Protocol Server Message Block-User Datagram Protocol Simple mail transfer protocol Simple network management protocol Simple network management protocol-trap Software Validation Protocol Trivial file transfer protocol Destination Options Table 11 lists the destination options available in the Instant UI. You can allow or deny access to any or all of these destinations depending on your requirements. Table 11 Destination Options Service Description To all destinations To a particular server Except to a particular server To a network Except to a network Access is allowed or denied to all destinations. Access is allowed or denied to a particular server. You have to specify the IP address of the server. Access is allowed or denied to servers other than the specified server. You have to specify the IP address of the server. Access is allowed or denied to a network. You have to specify the IP address and netmask for the network. Access is allowed or denied to networks other than the specified network. You have to specify the IP address and netmask for the network. Example Access Rules This section provides procedures to create the following access rules.  Allow TCP service to a particular network  Allow PoP3 service to a particular server  Deny FTP service except to a particular server  Deny bootp service except to a particular network Allow TCP service to a particular network 1. Click the New link in the Networks tab. To define the access rule to an existing network, click the network. The edit link appears. Click the edit link and navigate to the Access tab. 2. In the Basic Info tab, enter the appropriate information. 3. Click Next and set appropriate values in the Security tab. Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide Instant Firewall | 93