Dell PowerStore 5200T EMC PowerStore Release Notes for PowerStore OS Version 3 - Page 9

Resolved Issues The following issues have been resolved in this release. Issue ID Functional Area Description MDT-369654 CloudIQ PowerStore does not appear in CloudIQ. MDT-425839 MDT-411128 MDT-404724 MDT-403607 MDT-397662 MDT-396826 MDT-396286 Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts After upgrading to PowerStore version 2.1.1.1 with a direct attached storage (DAS) configuration, if the host HBA sends both Fibre Channel (FC) and NVME over FC connection requests, the PowerStore appliance will accept the first FC connection request but then reject the second NVME over FC request because NVME over FC is NOT supported. As both requests come from the same WWPN originator, both connections will be rejected. In some rare conditions, the Marvell FC QLA driver might crash if memory allocation from the kernel space fails. This will result in a single node reboot. The node will reboot automatically, and normal functions will be restored without any manual intervention. PowerStore node may unexpectedly reboot due to a QLogic QED firmware and driver issue. PowerStore node may unexpectedly rebooted due to QLogic QED firmware and driver issue A "Job Failure" error appears after unmapping a volume from a host or host group when multiple hosts or hosts groups that are mapped to different volumes are selected. If an ESXi host is connected directly to a PowerStore cluster using Fibre Channel (FC) cables and the FC cables are swapped, the HBA may fail to log into the PowerStore cluster. PowerStore FC QLA driver causes hosts log in issues. MDT-395513 MDT-393744 MDT-383195 MDT-368559 Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts Connectivity - Hosts In rare conditions, a Fibre Channel (FC) initiator may be unable to re-log into the PowerStore target port due to FC connection change. A Fibre Channel (FC) initiator may be unable to log into the PowerStore target port after target port reset. In rare conditions where the switch in the Fibre Channel (FC) fabric is oversubscribed and there is flux in the number of devices on the fabric, a PowerStore node could reboot. PowerStore Node may reboot due to QLA driver issue and host cannot login. MDT-126502 MDT-405807 MDT-398246 MDT-397069 MDT-394978 Connectivity - Hosts Connectivity Networks Connectivity Networks Connectivity Networks Connectivity Networks If a volume is unmapped when there is activity on the volume, the following error message appears: "Error while detaching host from volume". This message will also appear, if you try unmapping a volume from a host while an import is in progress. iSCSI discovery may work incorrectly on a multi-appliance cluster after storage network reconfiguration. The firmware on the 4-port card or Ethernet IO Module, if present, may become unresponsive and hang. This can result in a single-node reboot. A SLIC added after system initialization may later result in SFP information showing as missing and may result in alerts. This does not impact the usability of the ports. In specific releases the 256 initiator limit per PowerStore Fibre Channel port was not being enforced. If this limit is surpassed this could lead to unexpected behavior such as port resets and even node reboots. Resolved Issues 9