Dell PowerVault 221S Rack-to-Tower Conversion Guide - Page 3
Safety Instuctions, Precautions for Rack-Mountable Products - storage
View all Dell PowerVault 221S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
This conversion guide provides instructions for trained service technicians in removing one or more Dell™ systems from a rack cabinet and converting the system to a tower (or deskside) version. One rack-to-tower conversion kit is required for each system to be converted from a rack version system to a tower version system. CAUTION: The system may be very heavy when fully loaded. To prevent personal injury, do not attempt to move the system by yourself. Safety Instructions Use the following safety guidelines to ensure your own personal safety and to help protect your server, storage system, or appliance from potential damage. For complete safety, regulatory, and warranty information, refer to your System Information document. Precautions for Rack-Mountable Products Observe the following precautions for rack stability and safety. Also refer to the rack installation documentation accompanying the system and the rack for specific warning and/or caution statements and procedures. Servers, storage systems, and appliances are considered to be components in a rack. Thus, "component" refers to any server, storage system, or appliance, as well as to various peripherals or supporting hardware. WARNING: Installing Dell system components in a Dell rack without the front and side stabilizers installed could cause the rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always install the stabilizers before installing components in the rack. WARNING: After installing system/components in a rack, never pull more than one component out of the rack on its slide assemblies at one time. The weight of more than one extended component could cause the rack to tip over and injure someone. NOTE: Your Dell system is safety-certified as a free-standing unit and as a component for use in a Dell rack cabinet using the Dell customer rack kit. The installation of your system and rack kit in any non-Dell rack cabinet has not been approved by any safety agencies. It is your responsibility to have the final combination of system and rack kit in a non-Dell rack cabinet evaluated for suitability by a certified safety agency. Dell disclaims all liability and warranties in connection with such combinations. • Do not move large racks by yourself. Due to the height and weight of the rack, Dell recommends a minimum of two people to accomplish this task. Rack-to-Tower C onversi on Gui de 1-1