Dell PowerVault MD3200 SMI-S Provider Installation Guide - Page 13

3 Managing SMI-S Provider Starting and Stopping the OpenPegasus CIM Server For Windows To start or stop the OpenPegasus CIM server: • Open the Services window and locate the cimserver service. Right-click cimserver service and select start or stop. Or • In the command prompt: To start the service, type: net start cimserver To stop the service, type: net stop cimserver For Linux To start or stop the OpenPegasus CIM server, on a terminal window: To start the service, type: cimserver To stop the service, type: cimserver -s Adding or Removing a Storage Array From SMI-S Provider At installation, you are prompted to enter the IP addresses into a file. After this initial setup, the SMI-enabled client must use the SMI-S Provider proxy server system management profile to add or remove devices. NOTE: When a storage array is added, an IP address of only one of the management ports of the storage array must be supplied (and not both management ports). Entering the IP addresses for both management ports of a single storage array causes unpredictable behavior of the SMI-S Provider. Managing SMI-S Provider 13