Dell Precision M6400 Service Manual - Page 24
Replacing the Secondary Hard Drive HDD2
View all Dell Precision M6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Hard Drive: Dell Precision M6400 Service Manual 7. Remove the interposer from the HDD2 or the place-holder, and set the interposer aside. Replacing the Secondary Hard Drive (HDD2) CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance. NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive. NOTICE: Use firm and even pressure to slide the hard drive into place. Excessive force may result in damage to the connector. 1. Connect the interposer you removed in step 7 of the removal procedure to the new HDD2. 2. Snap the carrier onto the HDD2 ensuring the two fit securely together. 3. Replace the two M3 x 3-mm screws that secure the HDD2 to the carrier. 4. Slide the posts on the carrier into the slots on the base assembly, then lower the HDD2 into place. 5. Replace the two M3 x 3-mm screws that secure the HDD2 to the computer. 6. Replace the base assembly cover (see Replacing the Base Assembly Cover). 7. Follow the procedures in After Working on Your Computer. 8. Install the operating system, drivers, and utilities for your computer, as needed. For more information, see the Setup and Quick Reference Guide that shipped with your computer at support.dell.com. Back to Contents Page file:///T|/htdocs/systems/wsm6400/en/sm/hdd.htm[11/16/2012 10:26:26 AM]