Dell XPS Gen 4 Owner's Manual - Page 82
Integrated Devices, Network Interface Card, Close the computer cover
View all Dell XPS Gen 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
www.dell.com | support.dell.com 8 Press the retention arm into place, securing the card(s) in the computer. retention arm alignment guide alignment bar filler bracket NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment. 9 Connect any cables that should be attached to the card. See the documentation for the card for information about the card's cable connections. NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 10 Close the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on. 11 If you installed an add-in network adapter and you want to disable the integrated network adapter: a Enter system setup (see page 119), select Integrated Devices, and then change the setting for Network Interface Card to Off. b Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the integrated connector on the back panel. 12 Install any drivers required for the card as described in the card documentation. Removing a PCI Card 1 Follow the procedures in "Before You Begin" on page 67. 2 Press the lever on the card retention arm and raise the retention arm. 3 If necessary, disconnect any cables connected to the card. 4 Grasp the card by its top corners, and ease it out of its connector. 82 Removing and Installing Parts