Denon 589BA Owners Manual - Page 41

Getting Started Connections Setup Playback Remote Control Information Troubleshooting Specifications ENGLISH Searching Categories 1 Press [o p]. CATEGORY SEARCH CAT: Pops Channel category 2 Use [o p] to select the category, then use [ui] to select the desired station. • "UPDATING" is displayed while the encording code is being updated. • "SIRIUS UPDATING" is displayed when updating SIRIUS tuner firmware. • Refer to "Troubleshooting" (vpage 52) regarding other messages. Parental Lock 1 Tune to the channel you want to lock. 2 Press [ENTER] for at least 3 seconds. "Code: [ ]" is displayed. 3 Enter the 4-digit lock code using [uiop]. When you enter the correct code, the corresponding channel is locked. 4 Press [ENTER]. iPod® Playback The music on an iPod can be played by using the control dock for iPod (ASD-1R, ASD-3N or ASD-3W, sold separately). The operation can also be performed using the buttons on the remote control unit. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. Preparations 1 Make the necessary preparations. qSet the iPod in the DENON control dock for iPod. (vSee the control dock for iPod's operating instructions.) wAssign the control dock for iPod's input. The input for the control dock for iPod is assigned to VCR by default. "System Setup" - "Input Setup" - "iPod Assign" (vpage 24) 2 Either turn or press [iPod] to select the input source assigned in step 1-w above. 3 Set [SOURCE CONTROL 1] to "AUDIO" and [SOURCE CONTROL 2] to "iPod/NETWORK". (v page 42 "Remote Control Unit Operations") 4 Press [MODE] and hold it down for a 2 seconds or more to select the display mode. To switch between modes, press and hold down the button. When remote mode is active, "Remote" is displayed. [Selectable mode] Browse mode Remote mode Display location Main unit display iPod display Playable files Active buttons Audio file Video file Remote control unit (AVR-589) iPod S Sz1 S A S Sz2 S S z1 : When using an ASD-3N or ASD-3W control dock for iPod. z2 : Video may not be output, depending on the combination of ASD-1R and iPod. • With the default settings, the iPod can be used connected to the VCR (iPod) connector. • Use the RESTORER mode to expand the low and high frequency components of compressed audio files and achieve a richer sound. The default setting is "Mode3" (vpage 32). • Press or [OFF] and set the AVR-589's power to the standby mode before disconnecting the iPod. Also switch the input source to one to which "iPod Assign" is not assigned before disconnecting the iPod. • When using an ASD-3N or ASD-3W control dock for iPod, refer to the respective manual to operate. • Channels under Parental Lock cannot be tuned in by performing Tuning Up/Down or by category search. • Channels stored in preset memory can be tuned in by the preset channel select operation, even if Parental Lock is applied. • When a channel to which Parental Lock is applied is being played, Parental Lock for that channel is cancelled by performing Step 2. • See "Edit Lock Cord" (vpage 25) for the method of changing Parental Lock Cord. • You can also set "Parental Lock" from the system setup (vpage 25).