Dewalt DW715 Instruction Manual - Page 5

Use of Miter Saw, Laser System, Compound Miter and Sliding, Miter Saws - compound miter saw

Get Dewalt DW715 PDF manuals and user guides View all Dewalt DW715 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

English Use of Miter Saw Laser System WARNING: Read all instructions for the Installation of Laser Power Supply and the Installation of Laser before using the Miter Saw Laser B System. NOTE: The machine must be connected to a power source. The Miter Saw Laser System is equipped with an ON/OFF switch (B). The Miter Saw Laser System is independent of the machine's trigger switch. Compound Miter and Sliding Miter Saws LASER ADJUSTMENT 1. Set the miter saw to 0˚ miter and 0˚ bevel. Cut the end of a board up to 6" (152mm) wide to make end of board square with fence. NOTE: The wider the board, the more accurate the adjustment must be. 2. To turn on the laser, press the ON/OFF switch (B). 3. Insert the trigger lock (C) into the miter saw until it snaps into place. The trigger lock is secured to the LPS. Remove 2.5mm hex wrench (D) for laser adjustments. C B D C 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
English
4
Use of Miter Saw
Laser System
WARNING:
Read all instructions
for the Installation of Laser Power
Supply and the Installation of Laser
before using the Miter Saw Laser
System.
NOTE:
The machine must be connected to a power source.
The Miter Saw Laser System is equipped with an ON/OFF switch
(B). The Miter Saw Laser System is independent of the machine’s
trigger switch.
Compound Miter and Sliding
Miter Saws
LASER ADJUSTMENT
1. Set the miter saw to 0˚ miter and 0˚ bevel. Cut the end of a
board up to 6" (152mm) wide to make end of board square
with fence.
NOTE:
The wider the board, the more accurate the adjust-
ment must be.
B
2. To turn on the laser, press the
ON/OFF switch (B).
3. Insert the trigger lock (C) into the
miter saw until it snaps into
place. The trigger lock is secured
to the LPS.
Remove 2.5mm hex wrench (D)
for laser adjustments.
C
C
D
B