Electrolux E36DF76TPS Complete Owners Guide English - Page 16
Installing (Ladder) Rack Supports, To install oven rack supports
View all Electrolux E36DF76TPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
16 Before Setting Oven Controls Installing (Ladder) Rack Supports Always install oven rack support before turning on the oven (when the oven is cool). To install oven rack supports: Insert the rack supports into the rack support brackets on the oven side as shown and put back screws at their original location. Replace Remove Oven Rack Support Bracket Figure 13: Set racks in support before securing with screws. To remove the oven rack supports for a self-clean 1. cycle: 2. 3. Remove the screw located over the rack support on each side. Pull up the support from the oven rack support brackets to disengage supports from the oven. If the rack supports are not removed, the self-clean cycle won't start. Always remove the left side support first. Installed on sliders To remove from sliders Pull oven rack forward and lift up off oven rack slider Figure 14: Removing and replacing sliding racks Removing and Replacing Sliding Oven Racks The glide racks can only be used in two positions. Be careful to ensure that the rack holes are aligned and set firmly into the glide rack holder when replacing a glide rack. (Figure 15) The flat portion of the racks may be removed from the tracks and used like a regular flat rack on all the other rack positions. Insert regular flat oven racks in any desired position. To place on sliders Figure 15: Sliding rack holes must be set into rack pins.