Electrolux E36DF76TPS Complete Owners Guide English - Page 25
When Self Clean is finished, Remove Racks
View all Electrolux E36DF76TPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Setting Oven Controls 25 To start a clean cycle: All oven racks, rack ladders, and accessories must be removed from the oven interior to avoid possible damage. If the oven racks are not removed they may discolor. The Luxury Glide™ oven racks must be removed before starting self clean to avoid damaging the glide ability of the rack. The Clean and -Remove Racks indicator lights will flash as a reminder to remove the racks before starting a self clean cycle. Refer to "Arranging, Removing, and Replacing Oven Racks" on page 15 for instructions for removing and replacing all racks. 1. Turn the function dial to clean. The Clean and -Remove Racks indicator lights will blink to remind you to remove the racks and rack ladders from the oven cavity (Figure 26). Remove all oven racks, rack ladders, and accessories from the oven interior to avoid possible damage. If the oven racks are not removed they may discolor. Bake Conv Bake Conv Roast Broil Clean -Lock -Remove Racks Figure 26: Initial clean selection 2. Turn the temperature adjust dial to clean. The Clean indicator light will be steady and the -Lock indicator light will blink while the door lock engages (about 15 seconds). Refer to Figure 27 below. Bake Conv Bake Conv Roast Broil Clean -Lock -Remove Racks Figure 27: Clean cycle initiated 3. Once the door lock is fully engaged the Lock light will illuminate continuously and the oven will begin a default 3 hour clean cycle. During this time the convection fan is off for the duration of the clean cycle. To start clean after cancelling: If self clean was cancelled shortly after being started, and the oven interior did not reach high self clean temperatures, the next clean cycle may be set as soon as the oven door unlocks from the cancelled clean cycle. If the oven reached high temperatures before the self clean cycle was cancelled, you may be required to wait up to 4 hours before the control will allow another self clean cycle to be started. To restart a fresh clean cycle after a power outage: If the self clean cycle was interrupted by a power failure, the oven may not be thoroughly cleaned. Another self clean cycle may be needed. Once power is restored, the oven has cooled and the door unlocks, set to clean for another cycle. To avoid possible burns use caution when opening the oven door after the self clean cycle has finished. The oven may still be very hot. Stand to the side of the oven when opening the door to allow hot air to escape. Do not force the oven door open when self clean is active. This can damage the automatic door-locking system. The door will not unlock until the oven has sufficiently cooled. Use caution when opening the door after self clean cycle is complete; the oven may still be very hot. When Self Clean is finished: 1. The Clean light will turn off and -Lock will remain lit while the oven is still hot. 2. Once the oven has cooled (about 1 hour) the -Lock light will go out. Attempting to force open the oven door before the light is out can damage the motor door latch. 3. When the oven interior has completely cooled, wipe away any residue or powdered ash with a damp cloth or paper towel. IMPORTANT! • The kitchen area should be well ventilated. Use an open window, ventilation fan or exhaust hood during the first self clean cycle to help eliminate the normal odors associated the initial clean cycle. • When self clean finishes the oven door will remain locked until the oven has cooled sufficiently. Allow about 1 hour for the oven to cool before opening the oven door. To cancel self clean, turn both control knobs to OFF. Allow enough time for the oven to cool and for the door to unlock before the door may be opened.