Epson C11C558001 User Manual - Page 22

Paper Handling, Never use the knob to adjust the top-of-form position; this may damage the, printer

Get Epson C11C558001 - LQ 590 B/W Dot-matrix Printer PDF manuals and user guides
UPC - 010343850040
View all Epson C11C558001 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

4. Slide the left sprocket approximately 0.5 inch (12 mm) from the far left position and push the blue lever back to lock it in place. Then slide the right sprocket to match the width of your paper, but do not lock it. The triangle mark on top of the printer indicates the point furthest to the left where printing can begin. 5. Make sure your paper has a clean, straight edge. Then open both sprocket covers and fit the first four holes of the paper, with the printable side down, over the tractor pins. 6. Close the sprocket covers. Then slide the right sprocket to remove any slack in the paper and lock it in place by pushing the blue lock lever down. 7. Attach the paper guide and lay it flat on the printer. Slide the edge guides to the middle of the paper guide. 8. Turn on the printer. When the printer receives data, it automatically loads the paper and starts printing. If the first line on your page appears too high or low, change its position with the Micro Adjust function. (See page 33.) c Caution: Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position. 22 Paper Handling

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
22
Paper Handling
4.
Slide the left sprocket
approximately 0.5 inch
(12 mm) from the far
left position and push
the blue lever back to
lock it in place. Then
slide the right sprocket
to match the width of
your paper, but do not
lock it.
The triangle mark on top of the printer indicates the point furthest to
the left where printing can begin.
5.
Make sure your paper
has a clean, straight
edge. Then open both
sprocket covers and fit
the first four holes of
the paper, with the
printable side down,
over the tractor pins.
6.
Close the sprocket covers. Then slide the right sprocket to remove
any slack in the paper and lock it in place by pushing the blue lock
lever down.
7.
Attach the paper guide and lay it flat on the printer. Slide the edge
guides to the middle of the paper guide.
8.
Turn on the printer. When the printer receives data, it automatically
loads the paper and starts printing.
If the first line on your page appears too high or low, change its position
with the Micro Adjust function. (See page 33.)
c
Caution:
Never use the knob to adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.