Epson PowerLite 9300i Product Information Guide - Page 18

EPSON PowerLite 9300i Projector Replacing the Lamp The projection lamp lasts up to 7000 hours. It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The message LAMP REPLACE appears on the screen when the lamp comes on and the lamp warning light is flashing orange. To maintain projector brightness and image quality, replace the lamp as soon as possible. ❏ The lamp warning light burnt out). is flashing red (the lamp is Contact your dealer or call EPSON at (800) 873-7766 in the United States for a replacement lamp. Request part number V13H010L26. In Canada, please call (800) 463-7766 for dealer referral. Follow these steps to replace the lamp: 1. Turn off the projector. 2. When the power light stops flashing, unplug the power cord and let the projector cool. Warning: Let the projector cool for at least half an hour, if it has been on. The lamp is extremely hot immediately after use. 3. If the projector is mounted on the ceiling, remove the rear cover. 5. Loosen the three screws holding the lamp in place (you can't remove them). 6. Grasp the wire handle as shown and pull the lamp straight out. 1 2 7. Gently insert the new lamp. 8. Once the lamp is fully inserted, tighten its screws and replace the cover. (The projector won't come on if the lamp cover is loose.) 9. Reset the lamp timer (select Reset Lamp Timer in the projector's About menu). Release tab to remove rear cover 4. Loosen the lamp cover screws (you don't need to take them out all the way). Then remove the cover. 18 - EPSON PowerLite 9300i Projector 10/03