Epson TM-U950P Operation Manual - Page 34
Notes, printer power is turned on. If the DIP switch setting is changed
View all Epson TM-U950P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Set 2 SW Function 2-6 Internal use 2-7 I/F pin 6 reset signal 2-8 I/F pin 25 reset signal ON Fixed Enabled Enabled OFF Disabled Disabled Notes: When pin 6 of the interface connector is used for the reset signal, the printer is reset at MARK on the RS-232 level. When pin 25 of the interface connector is used for the reset signal, the printer is reset at SPACE on the RS-232 level or at HIGH on the TTL level. DIP switches excluding switch 2-1 (Auto line feed) and switches 2-7 and 2-8 (interface reset signal) are effective only while the printer power is turned on. If the DIP switch setting is changed after the printer power is turned on, the change is not effective. If DIP switch 2-7 or 2-8 is on while the printer power is turned on, the printer may be reset, depending on the signal state. DIP switches should not be operated while the printer power is turned on. 1-24 Setting Up the Printer